HGC-2 Series

The highly cost effective HGC-2 is designed to control a generator driven by a hydraulic motor where speed is controlled by a proportional solenoid valve, either directly at the motor or as part of the pump compensator.

The HGC-2 is a closed loop controller that monitors the AC line voltage from the generator output for outer loop closure and provides the necessary current to a valve coil in order to maintain the desired generator frequency.  The HGC-2 has a single LED indicator on the top of the unit to provide an overview of the operating status.

HGC-2
  • CE
Specifications Downloads How To Order
X
Item HGC-2 Description
Function Hydraulic Generator Controller Closed loop controller that monitors the AC line voltage from the generator
Number of Coils 1 Single 600 mAmps, 1.2Amps or 2.5Amps – See Order Guide
Control Input Frequency 100 to 250 VAC (RMS), 50/60Hz
Connector 8-Pin Deutsch
Mating Connector Kit P/N: 999-10073
Graphical User Interface (GUI) P/N: 023-00228 Set-up & Diagnostic software – Free Download
HGC-2 Programming Cable P/N: 999-10166 USB connection
Physical 94L x 94W x 13H mm 2 x # 8 Mounting screws
Mobile Equipment IP67 (Module Only) Solid potted
Temperature ºC -40 to +75 Deg. C Operating
Voltage 9 to 28 VDC Reverse polarity protection and transient protection
Certifications CE Declaration of conformity

 WARNING: This product may expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information about California Propsition 65, go to www.P65Warnings.ca.gov or visit our California Proposition 65 page.

Additional product documentation can be found on our product support website or by clicking the Help Center button above.

Model Description
HGC2-06 600mA current range
HGC2-12 1200mA current range
HGC2-25 2500mA current range
999-10228 Prototype harness
999-10166 Communication cable
999-10073 Mating connector kit

The current range represents the maximum current output available. The module output current should ideally just exceed or equal the valve selected.

Search form