Hello Everyone,
Is there any way, in Powervision 2.6, to change what the Source Address is on a CANport for a specific device? Not the Source Address the display is claiming, but say I want to change from looking for PGN 61444 SPN 190 (engine speed) on Source Address 0 to looking for it on Source Address 1.
With "Address Type" set to Static Address,
I am looking at the "Source Override" option next to "Source Address" under CANPort 1 (Engine Device), on a PV450 config. What does this do?
Please advice
Thank you.
Source Address Override
- Ocelot
- Posts: 77
- Joined: Thu Oct 06, 2011 10:43 am
Source Address Override
Kyle Bruneau
Applications Engineer - MurCal Inc
Applications Engineer - MurCal Inc