Dear All

I am working on a project where i have 2nos MeCAN( sender input and switch input ), 1no XM500, 1no PV450 and 1no.HV750.

Basically PV450 and HV750 displays are required to show process value received by MeCANs and XM500 module. In short PV450 and HV750 will have same data for displaying.

PV450 is in Engine Room and HV750 is in Wheel house.

Please suggest appropriate solution.

Regards
Zakir Sayed

I assume that the 450 and 750 simply have to display the parameters from the XM500 and MeCAN?

If so, the MSTD configurations are a good place to start and then modify from there.

There are quite a number of MeCANs and XM500 configurations. What parameters are these devices trying to track?

Thanks,

Brian McRae
Enovation Controls