XM500

The XM500 module is a configurable Input/Output (I/O) module designed to bring analog and digital inputs and output onto the SAE J1939 CAN.

The XM500 is ideally suited to bring the additional information needed onto the J1939 CAN bus and can be configured to broadcast fault codes and activate digital outputs per input condition such as fuel level low, hydraulic oil temperature high, etc. Because the XM500 broadcasts information using the J1939 standard protocol, the information can be displayed using standard J1939 display modules, such as the PowerView® 101.

XM500
  • CE
Specifications Downloads How To Order
X

Electrical

  • Power Input: 8 to 28VDC
  • Communication Ports: CAN J1939
  • Operating Temperature: -40°F to 185°F (-40°C to 85°C)
  • Digital Inputs: 4 – Ground or battery positive activation
  • Digital Outputs*: 2 Sinking (500 mA)
  • Product Weight: 10 ounces
  • Shipping Weight: 12 ounces
  • Shipping Dimensions: 4” x 6” x 2”
    *(Outputs are NOT reverse polarity protected. Damage will occur if B+ is connected to the outputs. Damage incurred from improper installation is not covered under the Murphy limited warranty policy.)
  • Thermocouple Input1: Type K and Type J
  • Analog Inputs2:
    • 1 – Battery Supply Voltage (dedicated)
    • 7 – Configurable as 0-5VDC, 4-20mA, resistive senders3 or used as an additional digital input
  • Speed Sensing Input: Magnetic pickup (2 to 120VAC RMS from 30 to 10,000 Hz)

1When the thermocouple input is used, only 5 resistive, 4-20 mA, or 0-5 VDC can be used instead of 7.

2Analog inputs can be exchanged for digital inputs (battery ground activation only) for a total of 11 digital inputs.

3Other resistive senders can be supported. Contact Murphy’s Industrial Panel Division for programming charges.

 WARNING: This product may expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information about California Propsition 65, go to www.P65Warnings.ca.gov or visit our California Proposition 65 page.

Additional product documentation can be found on our product support website or by clicking the Help Center button above.

Part Number Model/Description Notes
78700420 XM500 Murphy Standard* Module
78700534 XM500 Configuration Tool Tool
30000669 6’ harness with terminating resistor Wire Harness
30000685 6’ harness without terminating resistor Wire Harness
30000670 12’ harness with terminating resistor Wire Harness
30000686 12’ harness without terminating resistor Wire Harness

* To determine other configurations, review XM500 Config & Wiring documents.

Search form